Do your turn signals blink fast or do you have an indicator light after installing LEDs? If so installing a resistor with the LED bulb will eliminate this problem. The Load Resistors will mimic the resistance of the halogen bulbs to eliminate these errors. Simply wire between the power and ground wires for the effected circuit and enjoy. Resistors are sold as a pair or 4pc. When choosing resistors you typically want to use one that is the same wattage at the bulb that is being replaced. *When using with LED bulbs: - 6 Ohm 50W resistors are ideal for use with signal and brake LEDs (typically work the best out of the 3 available for signals and brake lights) The following resistors are typically used when installing HID kits on the Dodge Ram's from 04-12 on trucks that use the stock dual filament bulbs. - 6 Ohm 50W (recommended or 07 models)

• 6Ohm 50W LED Load Resistors for LED Turn Signal, Tail / Break / Stop, Backup light bulbs. Anti Flicker / Hyper flash, Fix Error.
• This will solve LED related Turn Signal, Tail / Break / Stop, Backup light bulbs problems such as hyper flashing, no flashing or burnt out bulb indications
• One LED resistor is required for each LED bulb.
• Simply wire between the power and ground wires for the effected circuit and enjoy.
• 1 Year Warranty

6Ohm 50W LED Load Resistors for LED Turn Signal, Tail / Break / Stop, Backup light bulbs. Anti Flicker / Hyper flash, Fix Error.DDM Tuning